Optional Accessories (Sold Separately); Battery Removal/Installation - Hitachi DV 10DA Handling Instructions Manual

English

OPTIONAL ACCESSORIES (sold separately)

1. Battery (Model EB12, EB12S, EB12G, EB12B, EB12M,
EB12H)
2. Drill bit for brick.
Diameter, 6.5 mm, 8 mm, 9.5 mm, 10 mm
3. Drill bit for steel
Diameter, 2 mm, 5 mm, 6 mm
4. Drill bit for wood
Diameter, 10 mm, 13 mm
5. Plus driver bit
Bit No.
No. 1
No. 2
Bit No.
Optional accessories are subject to change without notice.
APPLICATION
For drilling brick, etc. and for making base holes for
plugs, anchors, etc.
For drilling wood, metal, plastic, etc.
For driving and removing of wood screws, tapping
screws, etc.
Table 1
Before Blinks
charging (RED)
While Lights
charging (RED)
Blinks
Charging
(RED)
complete
Charging
Flickers
impossible
(RED)
Lights
Charging
impossible (GREEN)
<UC14YF and UC14YF2 only>
6

BATTERY REMOVAL/INSTALLATION

1. Battery removal
2. Battery installation
CHARGING
Before using the impact drill, charge the battery as
follows.
1. Connect the charger's power cord to an AC outlet.
2. Insert the battery into the charger.
Screw size
2 – 2.5 mm
3 – 5 mm
CAUTION
3. Charging
(1) Pilot lamp indication
Indications of the pilot lamp
Lights for 0.5 seconds. Does not light for
0.5 seconds. (off for 0.5 seconds)
Lights continuously
Lights for 0.5 seconds. Does not light for
0.5 seconds. (off for 0.5 seconds)
Lights for 0.1 seconds. Does not light for
0.1 seconds. (off for 0.1 seconds)
Lights continuously
Hold the handle tightly and push the battery latch to
remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
Insert the battery while observing its polarities (see
Fig. 2).
When the power cord is connected, the charger's pilot
lamp will blink slowly. (At 1-second intervals.)
<UC12Y>
Position the battery so that the nameplate faces
toward the ventilation slots of the charger and push
in the battery until it contacts the bottom plate. (See
Figs. 1 and 3.)
<UC12YA, UC14YF, UC14YF2>
Position the battery so that the nameplate faces
toward the caution plate of the charger and push in
the battery until it contacts the bottom plate. (See
Figs. 1 and 3.)
If the battery is inserted in the reverse direction, not
only recharging will become impossible, but it may
also cause problems in the charger such as deformed
charging terminals.
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously
in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals.) (See
Table 1)
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or
the rechargeable battery.
Malfunction in the bat-
tery or the charger
The battery temperature
is high, making recharg-
ing impossible.