Cisco Catalyst 2960 Software Configuration Manual page 854

Displaying MLD Snooping Information
To display MLD snooping information, use one or more of the privileged EXEC commands in
Table
Table 36-2 Commands for Displaying MLD Snooping Information
Command
show ipv6 mld snooping [vlan vlan-id]
show ipv6 mld snooping mrouter [vlan vlan-id]
show ipv6 mld snooping querier [vlan vlan-id]
show ipv6 mld snooping address [vlan vlan-id]
[count | dynamic | user]
show ipv6 mld snooping multicast-address vlan
vlan-id [ipv6-multicast-address]
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
36-12
36-2.
Purpose
Display the MLD snooping configuration information for all VLANs on
the switch or for a specified VLAN.
(Optional) Enter vlan vlan-id to display information for a single VLAN.
The VLAN ID range is 1 to 1001 and 1006 to 4094.
Display information on dynamically learned and manually configured
multicast router interfaces. When you enable MLD snooping, the switch
automatically learns the interface to which a multicast router is
connected. These are dynamically learned interfaces.
(Optional) Enter vlan vlan-id to display information for a single VLAN.
The VLAN ID range is 1 to 1001 and 1006 to 4094.
Display information about the IPv6 address and incoming port for the
most-recently received MLD query messages in the VLAN.
(Optional) Enter vlan vlan-id to display information for a single
VLAN.The VLAN ID range is 1 to 1001 and 1006 to 4094.
Display all IPv6 multicast address information or specific IPv6
multicast address information for the switch or a VLAN.
•
•
•
Display MLD snooping for the specified VLAN and IPv6 multicast
address.
Enter count to show the group count on the switch or in a VLAN.
Enter dynamic to display MLD snooping learned group information
for the switch or for a VLAN.
Enter user to display MLD snooping user-configured group
information for the switch or for a VLAN.
Chapter 36 Configuring IPv6 MLD Snooping
OL-26520-01