Hitachi CP-SX635W Service Manual page 42

Preparation for attaching the duct
Wiring when attaching the duct
(1) Pass the #2056 through the incision of duct, and attach it to the duct absorbing the excessive
length with tape. #2056 have to be along the side of duct.
(2) Pass the cable of #6800 and R/G fan through the duct hole, and attach them to the duct
absorbing the excessive length with tape.
(Cable is fixed with tape, so it is impossible to draw out the cable even if the cable length becomes insufficient at the later procedure.)
SM0321
fan
WIRING DIAGRAM 6
Preparation for attaching the battery board
Connect the CNBAT to the battery board first.
Unit the connector with tape (L25=mm) to prevent
being come off. (Bends the corner of the tape)
Battery board
(EL06 mounted surface)
HITACHI