Hitachi CP-SX635W Service Manual page 38

Wiring of the noise filter board
Wiring of the noise filter board
(1) Style the CNFG.
Style the CNFG cable like above diagram.
It is to prevent to lift the engine when attaching the engine.
SM0321
Wiring of the ballast power supply
Wiring of the ballast power supply
(1) Attach the CNBAR to the standing board.
(2) Pass the CNBAR through the ballast holder's hole. Then, put the CNBAR along the back.
Pinch the CNBAR with the two bosses.
(3) Pass the CNBAR through the two hooks at the side of the ballast holder.
The back of the ballast holder
hole
ballast holder
(reverse)
Pass the CNBAR through the ballast
holder's hole. Then, pinch the CNBAR
with the two bosses.
Make sure there is no cable loosening from the standing
board to the hook.
Area of Importance
WIRING DIAGRAM 2
Side of the ballast
ballast
ballast holder
hook
HITACHI