Troubleshooting - Philips HDD100 User Manual

If a fault occurs, first check the points listed below. before taking the set for repair. If you
are unable to remedy a problem by following these hints, consult your dealer or service
center.
For further help, please also check out the hdd100 FAQ list at
http://www.audio.philips.com
WARNING:
Do not open the set as there is a risk of electric shock! Under no circumstances should you try
to repair the set yourself, as this will invalidate the warranty.
Q. No display / sound
Battery weak.
– Charge the player via the supplied power adapter and press
– Operate your Jukebox using the power adapter.
– Check adapter and wall jack connection. Switch on power supply at wall
outlet.Press and hold
Headphones not properly connected.
– Insert headphone plug into the remote control jack completely. Make sure you
also insert the remote control jack in the set properly.
Make sure you have the required computer and software.
– See page 6, Minimum system requirements
Q. Malfunction. No reaction to controls
Possible electrostatic discharge.
– Reset your Jukebox. Press and hold
seconds to switch off. Press
e.g. your songs, recordings or downloaded files on your Jukebox is not
affected when resetting in this way.)
Q. Sound skips during playback on my Jukebox
Compression level of your WMA or MP3 files may be different from the supported
format of your player.
Please see page 31, Supported playback formats for details.
–
or www.philips.com/support.
POWER 2;
until display turns on (minimum 1 second).
VOLUME +
POWER 2;

Troubleshooting

and 3,
I11
to switch on again. (File content
2;.
POWER
simultaneously 2
33