Advertisement
4. Plug the TARGA2000DV board into the PCI slot that is
closest to the CPU (or the next closest slot, if the board
will not physically fit into the closest slot). Here, firmly
mount the board spacer between the guide rails on the
personal computer. The assembly diagram shown below
is intended as an example. The actual connection
locations may differ depending on the model of computer
used.
Insert the video compression boars with board spacer attached.
Illustration of image compression board inserted into PC.
Connect the ground wire of the video compression board (board
spacer) to the chassis (metal portion) of the system unit. (Unscrew
the screw and then use it to secure the wire in place.)
5. Connect the CA206 cable that was provided with the
TARGA2000DV board. Plug the connector labelled
"TARGA2000DV"
into
TARGA2000DV board, plug the connector labelled "VGA"
into the connector on the video card, and connect the
connector labelled "MONITOR" to the monitor cable.
The rail guides
on the personal
computer
the
connector
on
the
6. Store the screws and cover that were removed in a safe
place.
7. Turn the power on and start up WindowsNT.
8. Next, install the driver. Load the CD-ROM of the software
package, and execute "\targa\disk1\setup.exe" of the File
Manager, of the CD-ROM.
9. Follow the instructions to install the driver from the CD-
ROM. Operate according to the procedures below.
1)The window for Truevision TARGA2000DV V1.0 Setup
appears.
Click
.
Next
2)The Product Type Inquiry window appears.
Select the type of board to use, and click
For analog type, select "TARGA2000DV" (default).
For SDI type, select "TARGA2000DV SDX".
(When the type is selected, is displayed.)
3)The Choose Destination Location window appears.
Click
Next
.
4)The Select Program Folder window appears.
Click
Next
.
5)Installation begins.
6)The Readme window appears.
Click on the upper-right of the window and close it.
7)The Installation Completed Successfully window
appears. Select "Yes, I want to restart my computer
now".
(When this is selected, is displayed.)
Click
Finish
.
10.Restarts after installation.
At this point, remove the CD-ROM from which the driver
was installed.
6
Next
.
Advertisement
