Ip Settings - Cisco CTS-SX10-K9 Getting Started Manual

Cisco TelePresence SX10 Quick Set
SX10 Quick Set

IP settings

(When not set by a provisioning system)
On the Setup assistant, you can select the IPv4 settings for the
system. If you wish to change the IP settings from the default
dual stack setting to either IPv4 or IPv6, you can do that on the
web interface.
The system's IP configuration is by default set to dual stack.
This means that the network interface can operate on both
IP versions, and has both an IPv4 and an IPv6 address at the
same time. The IP parameters can be assigned automatically
by the network, or you can set everything manually.
If you want to set the parameters manually, please contact your
network administrator to obtain the required parameters.
If your system is provisioned automatically, these IP settings
may be overridden by the provisioning system.
If an IPv4 or IPv6 address is already assigned to the system,
you will find it under Settings: Navigate to the user name in the
upper left corner and select Settings.
To change the IPv4 settings for the call, navigate to the user
name in the upper left corner and select Settings. Select
Assistant, and proceed to the IPv4 section.
Back to task overview
D15117.01 SX10 Getting Started Guide TC7.1, MAY 2014.
Contents Introduction
Select
want automatic IP assignment; or
want to set the IP addresses manually.
If IP Assignment is Static: Set the IP addresses
Setup
Enter the
address. A soft keyboard appears when you
select an input field. Select ⎷ to confirm the
change
Configuration Configuration
Choose automatic or manual IP assignment
DHCP in the IP Assignment section if you
Static if you
IP Address, Subnet Mask and Gateway
Select Next to save the changes.
10
Getting Started Guide
Appendices
www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
Contact