Table of Contents
Advertisement
Changes and displays the settings of the paired Wireless Radio Receivers.
When you set the cursor on each item, the LINK lamp on the corresponding Wireless Radio
Receiver will flash.
Settings that can be changed or confirmed
NAME (Name)
The name of the Wireless Radio Receiver is displayed.
LINK (Link status)
When communications are available,
GP (Group)
You can check or change the group for the Wireless Radio Receiver.
The group can be changed only when the REMOTE lamp on the corresponding Wireless
Radio Receiver is lit up.
When the group is set to [OFF], the flash (sold separately) attached to the corresponding
Wireless Radio Receiver will not be used during wireless flash shooting.
ZOOM (Flash coverage)
You can check or change the zoom setting (flash coverage) for the flash attached to the
corresponding Wireless Radio Receiver.
The zoom setting (flash coverage) can be changed only when the zoom setting for the
flash is set to AUTO.
To change the settings
1. Set the cursor on GP (group) or ZOOM (flash coverage) for the desired Wireless Radio
Receiver using the top/bottom/right/left button on the control wheel, and then press the
center button.
2. Change the setting by turning the control wheel, and then press the center button.
CH SET (Channel setting)
Sets the channel used for wireless communication. When [AUTO] is selected, the most
appropriate channel according to the surrounding radio wave conditions will be selected
each time the product is turned on.
PAIRING (Pairing)
Pairs this product with a Wireless Radio Receiver.
is displayed.
Advertisement
Table of Contents
