Use Philips Easylink - Philips HTS3270 User Manual

Speakers Volume Setup
Front Left
Front Right
Center
Subwoofer
Rear Left
Rear Right
2
Press to change the volume level,
then press OK .
The test tone is emitted from the
»
speaker.
• Repeat the above setting for other
speakers until all the speakers'
output level sounds equally balanced.
• To exit the menu, press
To set the output delay time (centre and rear
speakers only)
1
Select [Speakers Delay] in the menu,
then press .
Speakers Distance Setup
Center
Rear Left
Rear Right
2
Press to set the delay time, then press
OK .
• Repeat the above setting for other
speakers until the sound output from
different speakers reach the listening
position at the same time.
• To exit the menu, press
Tip
•
Set a longer delay time if the centre speaker or
rear speaker is closer to the listening position
than the front speaker.
•
Allow 1 ms setting for every 1 foot distance
between the speaker and the listening position.

Use Philips EasyLink

0dB
Your product supports Philips EasyLink, which
0dB
uses the HDMI CEC (Consumer Electronics
0dB
Control) protocol. EasyLink-compliant devices
0dB
that are connected through HDMI connectors
0dB
can be controlled by a single remote control.
0dB
•
Philips does not guarantee 100%
interoperability with all HDMI CEC devices.
1
Turn on the HDMI CEC operations on
the TV and other connected devices. See
TVs/devices manual for details.
2
You can now enjoy the following Philips
SETUP .
EasyLink controls.
EasyLink
You can turn off or turn on all EasyLink
features.
One-touch play
When you connect your product to devices
that support one-touch play, you can control
your product and the devices with one
remote control. For example, when you
0MS press Play on your DVD remote control, your
TV automatically switches to the correct
0MS
channel to show the DVD content.
0MS
To enable One-touch play, a video disc must
be placed in the disc compartment before
operation.
One-touch standby
When you connect your product to devices
that support one-touch standby, you can use
your product remote control to switch your
product and all connected HDMI devices to
SETUP .
standby mode. You can perform one-touch
standby using the remote control from any of
the connected HDMI devices.
Note
EN 19