Table of Contents
Advertisement
3. Connecting the video recorder
Important for the United Kingdom
This apparatus is fitted with an approved moulded 10
Amp plug. To change a fuse in this type of plug pro-
ceed as follows:
1.Remove fuse cover and fuse.
1.
2.Fix new fuse which should be a
2.
BS1362 3A,ASTA or BSI approved type.
3.Refit the fuse cover.
3.
If the fitted plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fitted in its
place.
If the mains plug contains a fuse, this should have a
value of 3A. If a plug without a fuse is used, the fuse at
the distribution board should not be greater than 3A.
The severed plug must be destroyed to avoid a possi-
ble shock hazard should it be inserted into a 13A
socket alsewhere.
How to connect a plug:
The wires in the mains lead are coloured in accor-
dance with the following code:
BLUE- 'NEUTRAL' ('N')
BROWN- 'LIVE' ('L')
4.The BLUE wire must be connected to the terminal
4.
which is marked with the letter 'N' or coloured
BLACK.
5.The BROWN wire must be connected to the termi-
5.
nal which is marked with the letter 'L' or coloured
RED.
6.Do not connect either wires to the earth terminai in
6.
the plug which is marked with the letter 'E' or by
the safety earth symbol
green-and-yellow.
Before replacing the plug cover, make certain that the
cord grip is clamped over the sheath of the lead-not
imply over the two wires.
or coloured green or
Preparing the remote control for
operation
The remote control and its batteries are packed
separately in the original video recorder packag-
ing. You must install the batteries in the remote
control before use.
1.
1.
Take the remote control and the enclosed
batteries (2 batteries).
2.
2.
Open the remote control's battery compart-
ment and place the batteries in it as shown in
the picture and close the battery compart-
ment.
The remote control is now ready to use. Its
range is approximately 5 metres.
Connecting your video recorder to
the TV set
The necessary cable con-
nections must be made
before you can record or
playback TV programmes
using your video recorder.
We recommend that you use a scart cable to con-
nect your TV and video recorder.
What is a scart cable?
The scart or Euro AV cable serves as the universal
connector for picture, sound and control signals.
With this type of connection, there is practically no
loss of quality during the picture or sound transfer.
Connecting with a scart cable
Have the following cables
ready:
an aerial cable (1, supplied), a
scart cable (2, not supplied).
1.
1.
Remove the aerial
cable plug from your
TV set. Insert it into
the AERIAL at the
back of the video
recorder.
4
1
2
AERIAL
EN
Advertisement
Table of Contents
