Snapshot; Figure 5-5 Snapshot Configuration Interface - Honeywell H2W2PRV3 Software Configuration Manual

Performance Series IP Camera Software Configuration Guide
Parameter
Watermark
Sub Stream Enable
Code-Stream Type
Encode Mode
Resolution
Frame Rate
Bit Rate Type
Recommended
Bit Rate
Bit Rate
I Frame Interval

Snapshot

Figure 5-5 Snapshot Configuration Interface

28
Function
This function allows you to verify that the video has not been altered.
Select to enable the watermark function, and then type the watermark
text. The default watermark text is DigitalCCTV. The maximum length is
85 digits. Only numbers, letters, and the underscore character ( _ ) can
be used.
Select Sub Stream 1 or Sub Stream 2.
Click the check box to enable the extra stream. Sub Stream 1 is enabled
and Sub Stream 2 is disabled by default.
General bit stream (this is a unique option).
Select from four options for Encode Mode: H.264 (Main Profile), H.264H
(High Profile), H.264B (Baseline Profile), and MJPEG mode.
H.264: Main profile encoding mode.
H.264H: High profile encoding mode.
H.264B: Baseline profile encoding mode.
MJPEG: In this encoding mode, the video needs a larger bit stream to
guarantee the video definition. You can use the maximum bit stream
value in the Recommended Bit to get better video output.
There are multiple resolutions to select from the drop-down list. The
recommended bit stream value is different for each resolution.
PAL: 1‒25 fps; NTSC: 1‒30 fps.
Select either VBR or CBR.
Note You can select the video quality in VBR mode. The value ranges
from 1 to 6.
Recommended bit rate value according to the resolution and frame rate
you have set.
In CBR, the bit rate here is the maximum value. In dynamic video, the
system needs a lower frame rate or lower video quality to adapt to the
current bandwidth.
Set the number of P-frames between I-frames. The value ranges from 25
to 150. The default value is 50.
The recommended value for I Frame Interval is 2 times the frame rate
setting.