KitchenAid KFGR270LSS Technical Education page 41

3. To remove a burner ignitor:
a) Remove the grates, the griddle (if in-
stalled), and the sear plates.
b) Remove the control panel and the spark
module (see pages 4-2 and 4-3 for the
procedures).
c) Remove the two 5/8" hex nuts from the
front cover, pull the top of the cover
forward, and remove it.
5/8" Nuts
Front Cover
d) Remove the screw from the ignitor
bracket and collector box. NOTE: Hold
the collector box while removing the
screw since the screw secures both the
ignitor and the collector box.
Collector Box
Bracket &
Collector Box
Screw
e) Disconnect the burner ignitor wire con-
nector from the spark module.
Continued on the next page.
4-9
Bracket &
Collector
Box Screw
Burner Ignitor
Ignitor Wires