Sanyo DP32671 Service Manual page 27

Gear Middle 3
Rack Base
Gear Middle 4
(1)
Gear Pulley
(1)
Gear Main
Gear Middle 2
Gear Middle 1
Belt Loading
Gear Rack Disc
Spring Lifter
Rack Disc Sensor L
Spring Rack D Sensor
Rack Disc Sensor R
• Screw Torque: 1.2 ± 0.3kgf•cm (Screw (1))
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw (2))
NOTE
1. In case of the Gear Pulley installation, check if the value
of the Fig. 2-4-B is correct.
2. In case of the Clamper Ass'y installation,
check if the value of the Fig. 2-4-C is correct.
3. When installing the wire of the Loading Motor PCB Ass'y,
install it correctly as Fig. 2-4-D.
Manual soldering conditions
• Soldering temperature: 350 ± 5
• Soldering time: Within 4 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
4. In case of the Plate Lifter Ass'y installation, install correctly as
Fig. 2-4-E.
5. In case of the Rack Base installation, install correctly as
Fig. 2-4-F.
Gear Pulley
Loading Motor
Safety surface for pressing of the insert.
Clamper Ass'y
DISASSEMBLY INSTRUCTIONS
Pulley Motor
Clamper
(2)
Magnet
Loading Motor
Frame
Loading Motor
PCB
Plate Clamper
Plate Lifter
Lever Guide
Fig. 2-4-A
o
C
5.0 + 0, - 0.1mm
Fig. 2-4-B
Check Hook
Fig. 2-4-C
• Install wire from (1) to (2) in order.
BROWN(2)
RED(1)
• Install the Lever Guide as position (A)
Lever Guide
(A)
• To turn the Lever Guide as the arrow
• Install the Plate Lifter Ass'y as the arrow
Check Boss
B2-4
Loading Motor PCB Ass'y
Fig. 2-4-D
After Ass'y
Plate Lifter Ass'y
Lever Guide
Check Boss Ch
Plate Lifter Ass'y
Frame Sub Ass'y
Check Boss
k B
Fig. 2-4-E