Operation - Makita BPT350 Instruction Manual

OPERATION

Driving pin nails
WARNING:
Before pulling the trigger, always make sure that
•
the opening that pin-nails are fired contacts
material to be fastened. Just pulling the trigger fires
pin nails. Misfiring may cause personal injuries.
1
007732
Place flat the opening of the tool that pin-nails are fired
on the material to be fastened and hold the tool firmly
against the material. Then pull the lever and then pull the
trigger fully to drive the pin nail. The grip is shaped so
that the tool head can be held down securely with index
finger and thumb. After driving a pin-nail, be sure to
release the trigger fully.
When the head of driven pin-nail remains above the
surface of , drive the pin-nail while holding the pin nailer
head firmly.
007733
NOTE:
When the trigger is pulled after a quick trigger
•
action, the nailer may do nothing but operates
momentarily and may not fire pin nails. This is not
a trouble. At this time, release the trigger once, pull
it again and the pin nails can be fired.
Using the pin nailer continuously with the head of
•
fired pin nails remaining above the surface of
material to be fastened may cause damage to the
driver of the pin nailer and nailer jamming etc..
1. Trigger
2. Material to be
fastened
2
Removing jammed pin nails
WARNING:
Always make sure that the lever is released and
•
the battery cartridge is removed before removing
jammed nails .
1
2
007735
Remove the battery cartridge from the pin nailer.
Take out pin nails that remain inside the magazine.
Loosen bolt (A) and bolt (B) by turning them
approximately two turns using the hex wrench provided
with the pin nailer.
Remove driver guide cover by sliding it.
Remove stuck pin nails, debris, adhesives and
woodchips etc. from the passage for pin nails.
Check the driver guide cover for stuck pin nails or other
foreign matters and then secure it with these two bolts.
8
1. Bolt (B)
2. Driver guide
cover
3. Bolt (A)
3