Start Up The System - Cisco TelePresence MX200 G2 Installation Manual

Installing Cisco TelePresence MX200 G2 - Wheel Base
4
Snap on the cable channel lid
Lead the cables out at the
front or back as appropriate.
78-100248-02A0 | JUNE 2016 | © 2016 Cisco Systems, Inc. All rights reserved.
Snap on the cable
channel lid for strain relief.
5

Start up the system

• Connect to power and LAN/Ethernet.
• Switch on the system. The power switch is
placed next to the power connector at the
rear side of the system.
Wait while the unit starts up. Normally this takes a few
minutes. It may include automatic software upgrade and
restart of the Touch controller.
• Follow the instructions on the Touch controller.
Cisco Spark: To find more information on how to
get started with Spark registered systems, visit
http://help.ciscospark.com
articles for room systems.
Other services: For further information on set-up and
configuration, download the Getting Started Guide from the
Cisco web site, http://www.cisco.com/go/mx-docs
Never move the camera manually when power is switched
on; always use the camera control function on the Touch
controller to change the camera position.
and look for Getting Started
6