GE b30 Instruction Manual page 531

APPENDIX D: MISCELLANEOUS
Page Description
4- Added Engineer content
5- Updated IEC 61850 content
A- Updated FlexAnalog table for most UR products
Table D-3: Major changes for B30 manual version AC1 (English)
Page Description
--- General revision. Added online help and updated generic online help.
--- Deleted EAC logo from title page and deleted EAC certification from Approvals specifications because document not
translated into Russian
--- Added two Phase Directional Overcurrent elements throughout document, including ANSI table, specifications, FlexLogic
operands table, settings
--- Added Data Logger content to product description, specifications, settings, actual values, commands, Modbus memory map,
IMD table
--- Added Breaker Arcing Current content to product description, specifications, FlexLogic operands table, settings, FlexElement
tables, actual values, FlexAnalog table, features per product table, Modbus memory map, IMD table
--- Added Phase Overvoltage content to product description, specifications, FlexLogic operands table, settings, features per
product table, Modbus memory map, IMD table
--- Added Breaker Restrike content to product description, specifications, FlexLogic operands table, settings, features per
product table, Modbus memory map, IMD table
--- Updated number of Phase Instantaneous Overcurrent elements in FlexLogic operands table, settings, features per product
table, Modbus memory map
2- Updated several specifications, such as TOC, IOC, number of FlexLogic lines
4-30 Added FlexLogic Design and Monitoring using Engineer section to end of Interfaces chapter
5-38 Added PRT FUNCTION settings in Network section to enable/disable each Ethernet port
5-49 Updated IEC 61850 section
5-169 Updated number of FlexLogic lines from 512 to 1024 in FlexLogic Equation Editor settings section
10-1 Added Monitoring section
10-2 Added Retrieve Files section
C- Added Command Line Interface appendix
Table D-4: Major changes for B30 manual version AB2 (English)
Page Description
--- Updated document throughout, including numbers of elements and FlexLogic operands table
--- Added EAC compliance information throughout, including logo on title page, rear panel, added specifications, added life
expectancy and decommissioning, added sections on Repairs, Storage, and Disposal
--- Updated several figures for consistency
2-16 Added UR Signal Processing section
5- Updated IEC 61850 content
A- Updated FlexAnalog table
Table D-5: Major changes for B30 manual version AB1 (English)
Page Description
--- Updated document throughout and put into new template. Major revision.
--- Updated references to digital inputs/outputs to contact inputs/outputs for consistency
--- Added content for advanced IEC 61850, for example in the Settings and Actual Values chapters
2- Updated Order Codes and Specifications
3-9 Updated Figure 3-9 Typical Wiring Diagram to include delta and wye voltage input options
5-27 Added RS232 Baud Rate setting to Serial Ports section. Baud rate is now configurable, with two options.
5-31 Added Far-End Fault Indication (FEFI) section
B30 BUS DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL
REVISION HISTORY
D
D-3