Connect To The Network; Wired Connection; Wifi Connection - NETGEAR C7100V User Manual

Connect to the Network

You can connect to the modem router's network through a wired or WiFi connection. If you
set up your computer to use a static IP address, change the settings so that it uses Dynamic
Host Configuration Protocol (DHCP).

Wired Connection

You can connect your computer to the modem router using an Ethernet cable and join the
modem router's local area network (LAN).
To connect your computer to the modem router with an Ethernet cable:

1. Make sure that the modem router is receiving power (its Power LED is lit).
2. Connect an Ethernet cable to an Ethernet port on your computer.
3. Connect the other end of the Ethernet cable to one of the numbered Ethernet ports.
Your computer connects to the local area network (LAN). A message might display on
your computer screen to notify you that an Ethernet cable is connected.

WiFi Connection

You can connect to the modem router's WiFi network with Wi-Fi Protected Setup (WPS) or
you can find and select the WiFi network.
To use WPS to connect to the WiFi network:

1. Make sure that the modem router is receiving power (its Power LED is lit).
2. Check the WPS instructions for your WiFi-enabled computer or mobile device.
3. Press the WPS button on the modem router.
4. Within two minutes, on your computer or mobile device, press its WPS button or follow its
instructions for WPS connections.
Your computer or mobile device connects to the WiFi network.
To find and select the WiFi network:

1. Make sure that the modem router is receiving power (its Power LED is lit).
2. On your computer or mobile device, find and select the WiFi network.
AC1900 Cable Modem Voice Router
Connect to the Network and Access the Modem Router
18