Adding An Ima Link To An Ima Group - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

Chapter 3 Provisioning PXM1E Communication Links
Type <CR> to continue, Q<CR> to stop:

Adding an IMA Link to an IMA Group

Once you have established and configured an IMA group, you can begin adding IMA links to the group.
Use the following procedure to add an IMA link to an IMA group.
Enter the dspimagrps command to see the available IMA groups, as shown in the following example:
Step 1
MGXswitch.7.PXM.a > dspimagrps
Ima
Grp
--------------------------------------------------------------------------------
2.1
2.2
2.3
Enter the addimalnk <link> <group> command to add an IMA link to an IMA group. Replace <link>
Step 2
with the number of a line you want to add to the group. Enter the line number in the format bay.line,
where bay is always 2 on the PXM1E and the line number is the appropriate number as displayed in with
the dsplns command.
Replace <group> with the number of the group. Group numbers are displayed in the Ima Grp column of
the dspimagrps command display.
In the following example, the user adds line 1 to IMA group 2.1.
MGXswitch.7.PXM.a > addimalnk 2.1 2.1
To verify that the link has been added, enter the dspimalnks command.
Step 3
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
GTSM Dn Integ Time (msecs)
Num Tx Cfg Links
Num Rx Cfg Links
Num Act Tx Links
Num Act Rx Links
Least Delay Link
Tx Timing Ref Link
Rx Timing Ref Link
Group Running Secs
Alpha Val
Beta Val
Gamma Val
Tx OAM Label
Rx OAM Label
Test Pattern Procedure Status
Test Link
Test Pattern
Stuff Cell Indication (frames)
Version Fallback Enabled
Auto-Restart Mode
Rx IMA ID Expected
Auto-Restart Sync State
Min Tx Rx Tx Diff
Lnks Frm Frm Clk Delay
Len Len Mode (ms)
1 128 128 CTC 100
3 128 128 CTC 100
3 128 128 CTC 100
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
General PXM1E Configuration Procedures
: 4000
: 4
: 4
: 4
: 4
: 2.3
: 2.4
: 2.1
: 3999594
: 2
: 2
: 1
: 1
: 1
: Disabled
: Unknown
: 255
: 1
: true
: disable
: -1
: disable
NE-IMA
state
StartUp
StartUp
StartUp
FE-IMA IMA
state Ver
StartUp 1.0
StartUp 1.1
StartUp 1.1
3-35