Smc Active Led States - Cisco ASR 5000 Installation Manual

Applying Power and Verifying the Installation
Table 50: SMC Run/Fail LED States
Color
Green
Blinking
Green
Red
None

SMC Active LED States

The Active LED on the SMC indicates that the software is loaded on the card and it is ready for operation.
For the SMC installed in slot 8, this LED is illuminated green during normal operation. For the SMC installed
in slot 9, this LED is off during normal operation.
The possible states for this LED are described in the following table. If the LED is not green, use the
troubleshooting information in the table to diagnose the problem.
Table 51: SMC Active LED States
Color
Green
Description Troubleshooting
Card powered with no None needed.
errors detected
Card is initializing and/or This is normal operation during boot-up.
loading software
Card powered with Errors were detected during the POSTs. It is likely that the errors
error(s) detected were logged to the system's command line interface during boot.
Refer to the System Administration Guide for troubleshooting
information.
Card is not receiving Verify that the POWER LEDs on the PFUs are green. If they are
power not, refer to
troubleshooting information.
Verify that the power source is supplying ample voltage and
current to the chassis.
Verify that the card is properly installed per the instructions in
this document.
If all of the above suggestions have been verified, it is possible
that the SMC is not functional. Please contact your service
representative.
Description Troubleshooting
Card is active None needed for the SMC in slot 8. If green for the SMC in slot
9, verify that the SMC in slot 8 is installed properly according to
the instructions in this document.
Checking the LEDs on the SMC(s)
Checking the LED on the PFU, on page 137
ASR 5000 Installation Guide
for
141