Page 1
DATA SHEET TDA1510AQ 24 W BTL or 2 x 12 W stereo car radio power amplifier Product specification File under Integrated Circuits, IC01 INTEGRATED CIRCUITS January 1992...
GENERAL DESCRIPTION The TDA1510AQ is a class-B integrated output amplifier encapsulated in a 13-lead single in-line (SlL) plastic power package. Developed primarily for car radio application, the device can also be used to drive low impedance loads (down to 1,6 ).
Page 3
Philips Semiconductors 24 W BTL or 2 x 12 W stereo car radio power amplifier Fig.1 Functional diagram; heavy lines indicate signal paths. January 1992 Product specification TDA1510AQ...
Page 4
Philips Semiconductors 24 W BTL or 2 x 12 W stereo car radio power amplifier RATINGS Limiting values in accordance with the Absolute Maximum System (IEC 134) PARAMETER Supply voltage: operating non-operating non-operating, load dump protection Peak output current Total power dissipation...
Page 5
Philips Semiconductors 24 W BTL or 2 x 12 W stereo car radio power amplifier HEATSINK DESIGN EXAMPLE The derating of the encapsulation requires the following external heatsink (for sine-wave drive): ) = 3,5 K/W th j-mb 24 W BTL (4 ) or 2 12 W stereo (2 );...
Page 6
Philips Semiconductors 24 W BTL or 2 x 12 W stereo car radio power amplifier A.C. CHARACTERISTICS = 25 C; V = 14,4 V; f = 1 kHz; unless otherwise specified PARAMETER Bridge Tied Load application (BTL) Output power with bootstrap...
Page 7
Philips Semiconductors 24 W BTL or 2 x 12 W stereo car radio power amplifier PARAMETER Stereo application Output power; with bootstrap Output power; without bootstrap Frequency response Supply voltage ripple rejection Channel separation Closed loop voltage gain Noise output voltage (r.m.s.
Page 8
Philips Semiconductors 24 W BTL or 2 x 12 W stereo car radio power amplifier Notes to the characteristics 1. If V > V then I must be < 10 mA. 2. Closed loop voltage gain can be chosen between 32 and 56 dB (BTL), and is determined by external components.
Philips Semiconductors 24 W BTL or 2 x 12 W stereo car radio power amplifier APPLICATION INFORMATION (1) belongs to power supply. Fig.3 Test and application circuit; Bridge Tied Load (BTL). (1) belongs to power supply. January 1992 Fig.4 Test and application circuit; stereo mode.
Page 10
Philips Semiconductors 24 W BTL or 2 x 12 W stereo car radio power amplifier PACKAGE OUTLINE DBS13P: plastic DIL-bent-SIL power package; 13 leads (lead length 12 mm) DIMENSIONS (mm are the original dimensions) UNIT 17.0 0.75 0.48 24.0 15.5 0.60...
Philips customers using or selling these products for use in such applications do so at their own risk and agree to fully indemnify Philips for any damages resulting from such improper use or sale.