How To Register/Change Id Codes (Access Control Mode) - Sharp AR-650 Service Handbook

1.2.6

How to register/change ID codes (Access control mode)

When ID codes are registered, copies made will be classified according to each ID code. The copier
will not start unless one of the ID codes registered is keyed in.
<Preparation to enter the access control mode>
[0] [8] [6] [0] [0]
[PWR]
Procedure to register ID codes:
R [8] [START]
[PWR]
C1 [HELP]
Input next ID
Procedure to change ID codes:
R [8] [START]
[C]
(To cancel)
C2 [COPY]
Correct the
number of copies
[HELP]
(To skip)
"– – – –"
displayed
(Add ID)
[START]
[START] [1]
(Enabled)
(Memorizing)
"– – – –"
[E/S]
displayed
(Memorizing)
Input an ID code
of four figures
[C] (To correct)
ex: 0525
"– – – –"
[E/S]
displayed
(Memorizing)
[C]
"0525 1960"
displayed
[PWR]
"– – – –"
displayed
["0525 1960"]
(Memorizing)
Input the
number
of copies
Key in XXXXXX
Next ID code
displayed
[E/S]
(Input ID)
Warm up
1 - 33
[SET]
or [PWR OFF]
[INT]
ID code Counter value (7 digits)
"0525 "
displayed
Up to 120 ID codes
can be registered
C2
[E/S] [START]
(Memorizing)
[E/S] [START]
[START] Warm-up
[START] Warm-up
R
C1
[START] Warm-up
Warm up
Warm-up
ADJUSTMENT