Table of Contents
Advertisement
1. Switch off the engine and wait until the
blade comes to a standstill.
2. Pull the lever (1) upwards and turn it until
the desired cutting height is reached.
Locking steerable front wheel
On flat terrain, it is more comfortable to leave
the front wheel free to pivot. If you mow in
horizontal direction, it is necessary to always
lock the wheel.
Releasing steerable front wheel
Pull off the spring cotter (1) and insert it into
the hole at the handlebar console.
Locking the steerable front wheel
Insert the spring cotter (1).
14
1
1
Starting
Danger!
During startup, there is a risk of
injury caused by the rotating blade.
Make sure that no one is within the
danger zone of the blade. Do not tip
the device over to one side during
startup.
Danger!
If after startup the carburetor does
not close properly, fuel will overflow
and a fire hazard occurs.
Close the fuel valve and contact an
authorised service centre.
Starting the device
1. Place the device onto a flat surface, not in
high grass.
2. Open the fuel valve and the tank ventila-
tion.
3. Plug on the spark plug connector.
4. Set the engine stop switch to "I".
5. For cold start, set the accelerator switch to
position "choke"; otherwise, set it to medi-
um speed.
6. Pull the starter point slowly out until you
feel resistance then pull out quickly – en-
gine starts to run.
7. Let the starter rope retract slowly.
8. For mowing, set the accelerator lever to the
maximum speed.
Engaging the blade
1. Lift the blade clutch lever.
2. Press the latch knob at the blade clutch
lever.
3. Press the blade clutch lever towards the
handlebar – the blade starts to move.
Disengaging the blade when moving over
paths:
1. Release the blade clutch lever.
Advertisement
Table of Contents
