Specifications - Makita DPT351 Instruction Manual

ENGLISH (Original instructions)
1-1. Red indicator
1-2. Button
1-3. Battery cartridge
2-1. Indicator lamps
2-2. Check button
3-1. Trigger
3-2. Lever
4-1. Sliding door
5-1. Lever
6-1. Trigger
7-1. Bolts

SPECIFICATIONS

Model
Pin nail size
Pin nail magazine capacity
Dimensions (L x W x H)
Battery Cartridge
Net weight
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for pressing pin nails into
construction materials such as timbers.
Noise
The typical A-weighted noise level determined according
to EN60745:
Model DPT350
Sound pressure level (L
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Model DPT351
Sound pressure level (L
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total value determined according to
EN60745:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
7-2. Driver guide cover
8-1. Lamp
8-2. Lever
9-1. Driver guide
9-2. Pin nails
9-3. Magazine
9-4. Lock lever
10-1. Driver guide cover
10-2. Protrusion
10-3. Nose adapter
10-4. Holder
ENE068-1
ENG905-1
) : 75 dB (A)
pA
) : 74 dB (A)
pA
ENG904-2
2
) : 2.5 m/s or less
h
2
DPT350
0.6 x 18, 25, 30, 35 mm
130 pcs
227 mm x 79 mm x 245 mm
BL1430 / BL1440 /
BL1415N
BL1450
1.8 kg 2.0 kg
D.C. 14.4 V
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
12-1. Groove
12-2. Hook
12-3. Screw
13-1. Hex wrench
14-1. Trigger
14-2. Material to be fastened
16-1. Bolt (B)
16-2. Driver guide cover
16-3. Bolt (A)
DPT351
0.6 x 18, 25, 30, 35 mm
130 pcs
227 mm x 79 mm x 249 mm
BL1830 / BL1840 /
BL1815 / BL1815N /
BL1840B / BL1850 /
BL1820 / BL1820B
1.9 kg
D.C. 18 V
BL1850B
2.1 kg
ENG901-1