Turning Off - Toshiba e-STUDIO5506AC Quick Start Manual

Chapter 1 PREPARATIONS

Turning OFF

Follow the steps below. Check the following items before turning off the equipment.
• No jobs should be left in the print job list.
• The PRINT DATA lamp (blue) or the MEMORY RX lamp (green) should not be flashing.
(If the equipment is shut down while any of the above lamps are flashing, jobs in progress such as FAX
reception will be aborted.)
• No computer should access the equipment over a network, such as TopAccess.
• When the [ENERGY SAVER] button (green) is on or flashing on the control panel, or the touch panel screen is
still ON, do not press the main power switch to turn the power OFF. Stored data may be lost or the hard disk
may be damaged.
• If you press the [POWER] button while a job is running, a message is displayed asking if you want to delete
the current job and turn off the equipment.
Press the [POWER] button until you hear a "beep".
When turning the equipment back on after turning it off, wait for approximately 30 seconds.
When the equipment is not used for a long period of time:
Select [Shutdown] to select a shutdown option.
Check that the [ENERGY SAVER] button (green) has
stopped flashing and the touch panel screen is off.
Turn the power OFF with the main power switch.
16
You can then select how to turn the equipment
off. If you press [Hibernate] or [Shutdown], the
screen disappears and the equipment is turned
off after a short while.
If you press [Hibernate] the memory contents
are saved to the hard disk before turning the
equipment off. Select this if you want to start up
the equipment faster next time it is turned on.
If you press [Shutdown] the system is restarted
and the system's memory is initialized. Select
this if you will not use the equipment for a long
period.
The MAIN POWER lamp (green) turns off.