Table of Contents
Advertisement
C-20
Interactions (cont'd)
5.
Listed Directory Numbers (LDN) may be provided for the various satellite systems. Because
these LDNs will ring in only at the CAS key of the Attendant Console, indications to distinguish
among the multiple LDNs are not specifically available. However, the route number is displayed
and can be used to distinguish satellite systems.
6.
During the Day mode of operation, if all RLTs are busy, incoming COT calls will wait and
Ringback Tone is sent to the calling party.
7.
If the Attendant Console at the main system should switchhook flash to get Dial Tone from the
satellite and all ports are busy, Reorder Tone is sent to the Attendant Console. The Attendant
can switchhook flash COT party.
8.
The CAS feature allows Attendant Console to be located at both the main and satellite locations.
When the satellite location goes to the Night mode, translations are available to connect
incoming C.O. calls to the RLT circuits. This is accomplished by the ACSI command and the
NIGHT CONNECTION FIXED/FLEXIBLE [N-1, 2] feature.
9.
When the Night stations are located at the satellite PBX and no Attendant Console is provided,
a Night key must be installed at the satellite location to activate night service. When the key is
operated, the CAS operations are suspended, and incoming calls are terminated at the NIGHT
CONNECTION FIXED/FLEXIBLE station(s) [F-1, 2] or via TRUNK ANSWER FROM ANY
STATION [T-8]. When answered, the Night station can transfer the call to the main location via
the TIE trunks but not the RLT circuits. A PA-D07 (Attendant Console) circuit card must be
supplied to the satellite system.
10. PAGING ACCESS [P-1]: This feature allows the CAS Attendant to access paging equipment
located at the branch location upon answering an RLT call. See PAGING ACCESS
MEET-ME PAGING [M-1].
11. CODE CALLING ACCESS [C-21]: This feature allows the CAS Attendant Console to access
CODE CALLING equipment located at the satellite location upon answering an RLT call.
12. STATION MESSAGE DETAIL RECORDING [S-10]: SMDR is provided for calls extended by a
CAS Attendant Console.
Page 146
Centralized Attendant Service (CAS)
NEAX2400 ICS Business Features and Specifications
[P-1]
and
NDA-24143, Issue 4
Advertisement
Table of Contents
