Cisco Catalyst 3560-X Software Configuration Manual page 159

Chapter 1 Managing Switch Stacks
Beginning in privileged EXEC mode, follow these steps to assign a priority value to a stack member:
This procedure is optional.
Command
Step 1 configure terminal
Step 2
switch stack-member-number priority
new-priority-number
Step 3 end
Step 4 reload slot stack-member-number
Step 5 show switch stack-member-number
Step 6
copy running-config startup-config
Provisioning a New Member for a Switch Stack
Note This task is available only from the stack master.
Beginning in privileged EXEC mode, follow these steps to provision a new member for a switch stack.
This procedure is optional.
Command
Step 1 show switch
Step 2 configure terminal
Step 3
switch stack-member-number provision
type
Step 4 end
Step 5
show running-config
Step 6
show switch stack-member-number
Step 7
copy running-config startup-config
OL-25303-03
Purpose
Enter global configuration mode.
Specify the stack member number and the new priority for the stack
member. The stack member number range is 1 to 9. The priority value
range is 1 to 15.
You can display the current priority value by using the show switch user
EXEC command.
The new priority value takes effect immediately but does not affect the
current stack master. The new priority value helps determine which stack
member is elected as the new stack master when the current stack master
or switch stack resets.
Return to privileged EXEC mode.
Reset the stack member, and apply this configuration change.
Verify the stack member priority value.
(Optional) Save your entries in the configuration file.
Purpose
Display summary information about the switch stack.
Enter global configuration mode.
Specify the stack member number for the preconfigured switch. By
default, no switches are provisioned.
For stack-member-number, the range is 1 to 9. Specify a stack member
number that is not already used in the switch stack. See Step 1.
For type, enter the model number of a supported switch that is listed in
the command-line help strings.
Return to privileged EXEC mode.
Verify the correct numbering of interfaces in the running configuration
file.
Verify the status of the provisioned switch. For stack-member-number,
enter the same number as in Step 1.
(Optional) Save your entries in the configuration file.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Configuring the Switch Stack
1-27