Monitoring And Maintaining Lldp, Lldp-Med, And Wired Location Service - Cisco Catalyst 3560-X Software Configuration Manual

Chapter 1 Configuring LLDP, LLDP-MED, and Wired Location Service
Switch(config-civic)# county "Santa Clara"
Switch(config-civic)# country US
Switch(config-civic)# end
Beginning in privileged EXEC mode, follow these steps to enable wired location service on the switch.
Command
Step 1
configure terminal
Step 2 nmsp enable
Step 3 nmsp notification interval {attachment |
location} interval-seconds
Step 4 end
Step 5 show network-policy profile
Step 6
copy running-config startup-config
This example shows how to enable NMSP on a switch and to set the location notification time to 10
seconds:
Switch(config)# nmsp enable
Switch(config)# nmsp notification interval location 10
Monitoring and Maintaining LLDP, LLDP-MED, and Wired
Location Service
Command
clear lldp counters
clear lldp table
clear nmsp statistics
show lldp
show lldp entry entry-name
show lldp interface [interface-id]
OL-25303-03

Monitoring and Maintaining LLDP, LLDP-MED, and Wired Location Service

Purpose
Enter global configuration mode.
Enable the NMSP features on the switch.
Specify the NMSP notification interval.
attachment—Specify the attachment notification interval.
location—Specify the location notification interval.
interval-seconds—Duration in seconds before the switch sends the
MSE the location or attachment updates. The range is 1 to 30; the
default is 30.
Return to privileged EXEC mode.
Verify the configuration.
(Optional) Save your entries in the configuration file.
Description
Reset the traffic counters to zero.
Delete the LLDP neighbor information table.
Clear the NMSP statistic counters.
Display global information, such as frequency of transmissions, the holdtime for
packets being sent, and the delay time before LLDP initializes on an interface.
Display information about a specific neighbor.
You can enter an asterisk (*) to display all neighbors, or you can enter the
neighbor name.
Display information about interfaces with LLDP enabled.
You can limit the display to a specific interface.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-11