NEC UNIVERGE SV8300 Command Manual page 41

CONDITION
Commands which require a
reset of the blade after data
setting.
• Executed by CME0 Y=3
BLADE RESET
NOTE:
When CM10 Y=00: DXXX is executed, a blade reset by CME0 Y=3 is required only for LDT/
ODT/DTI.
Conditions for Using Commands
COMMANDS
CM04 Y=10-59>01, 02
CM05
CM08>644
CM10 Y=00:
X-XXXXXXXX, DXXX,
E000-E007,
FX-FXXXXXXXX
NOTE
CM13 Y=63
CM30 Y=00
CM35 Y=000, 001, 009,
020, 023, 025, 079, 100,
105, 113, 144, 291
CM41 Y=0>38, Y=1>20,
21, Y=2>50-68,
Y=3>20-24
CMA9
CMAA Y=00-02, 06, 09,
12, 13, 19
2-4
Chapter 2 PRECAUTION
CONDITIONS FOR USING COMMANDS
MEANINGS
Display Language for Multiline Terminal/
DESKCON LCD, Default Setting Patterns for
Multiline Terminal, Kind of Tone for IP Sta-
tion/TDM, Inquiry No. in Password Lock
State for DT700 Series, Single Line Tele-
phone ringing signal for Station-to-Station
connection, Single Line Telephone ringing
signal from a trunk, Special ringing signal for
Single Line Telephone ring, Setting of Ser-
vices, A-law/µ-law Setting for Each Unit
Blade Type, Trunk Blade Number
Basic Services
Station Number, Trunk Number, Blade Num-
ber
Station Class-2
Trunk Data
Trunk Route Data
System Timer Data
ISDN (PRI) D-Channel Assignment
DTI/BRT/PRT/CCT Functions
Continued on next page
NWA-033623-001 Rev.3.0
91ch2001.fm
NOVEMBER/12/2008