Honeywell Domonial cmi Quick Install Manual page 11

Programming
4. Programming with the TCU Keypad
ote that because the TCU is used for programming, the life of the battery will be reduced. A new
battery should be inserted before handover to the end user if programming takes longer than one hour.
SELECT LANGUAGE
< ENGLISH >
QUIT( ) YES(OK)
1-REGISTER
2-DEVICES
3-PARAMETERS
4-DATE & TIME
5-SYSTEM DIAG.
6-TRANSM.STATUS
7-RADIO SCAN
8-ABORT
9-SAVE+QUIT
4.1 Registering Peripheral Devices
After mounting the panel and attaching the cables, you must register each peripheral device at the control
panel.
1-REGISTER
2-DEVICES
3-PARAMETERS
4-DATE & TIME
5-SYSTEM DIAG.
6-TRANSM.STATUS
7-RADIO SCAN
8-ABORT
9-SAVE+QUIT
Hold down for 3 seconds
1
1-PROGRAMMING
2-RESTORE DEFAULT
3-IST MODE
4-QUIT
QUIT( )
MAIN MENU
Use the and keys to scroll through the choices, press
OK to confirm.
To register a device (including the keypad, if this is to remain on site),
select 1-REGISTER from the main menu (figure 4 above).
Insert the battery in the device to be registered.
YES(OK)
English
2
Press within 30 seconds
ENGINEER:
--------------
TYPE CODE
QUIT( ) YES(OK)
to cancel or press
11