System Speed Dial - NEC 48/192/IPK Administration Manual

System Speed Dial

*** Must be Programmed from a phone with System Admin (usually ext 100)
1. Press the F
EATURE
2. Enter a bin number: 00-79 for system
3. Enter 9 plus the desired telephone number to be stored (24 digits max)
4. Press H
OLD
5. Spell out name: Press # after each letter to move cursor to the right OR press C
to move the cursor to the left
6. Press F
EATURE
Use this keypad digit . . . When you want to. . .
1
2
3
4
5
6
7
8
9
0
*
#
CONF
HOLD
To USE System Speed dial:
1. Lift handset or press speaker key
2. Press Redial key
3. Enter desired code
OR: press SYS, use arrow keys to scroll OR press a letter on the dial pad then use arrow keys
to scroll
key, then the R
key if entering a name
key
Enter characters:
Enter characters:
Enter characters:
Enter characters:
Enter characters:
Enter characters:
Enter characters:
Enter characters:
Enter characters:
Enter characters:
Enter characters:
# = Accepts an entry (only required if two letters on the same key are
needed – ex: TOM). Pressing # again = Space. (In system programming
mode, use the right arrow Softkey instead to accept and/or add a
space.)
Clear the character entry one character at a time.
Clear all the entries from the point of the flashing cursor and to the right.
key
EDIAL
1 @ [ ¥ ] ^ _ ` { | } Æ ¨ Á À Â Ã Ç É Ê ì ó
A-C, a-c, 2.
D-F, d-f, 3.
G-I, g-i, 4.
J-L, j-l, 5.
M-O, m-o, 6.
P-S, p-s, 7.
T-V, t-v, 8.
W-Z, w-z, 9.
0 ! " # $ % & ' ( ) ô Õ ú ä ö ü α ε .
* + , - . / : ; < = > ? B E σ S 8 ¢ £
Page 5 of 8
key
ONF