Operating From The Remote Control - Black & Decker BPACT08 SERIES Instruction Manual

SET UP & USE

OPERATING FROM THE REMOTE CONTROL

The first part of the controls on the remote control are the same as those on the
control panel of the appliance.
You should therefore refer to the instructions in the chapter Operating from the
Control Panel to turn the appliance on and select the operating mode (Cool, Dry,
Fan) and the fan speed.
The following section describes the additional functions corresponding to the
controls on the bottom part of the remote control.
COOLING MODE
- Press the button to turn the appliance on.
- Press the MODE button ( ) to select COOL.
- Set the temperature using the
- To select fan speed, press the FAN SPEED button
required speed is selected (HIGH / MED / LOW / AUTO FAN).
NOTE: In COOLING mode, the appliance automatically removes excess moisture
from the atmosphere.
DEHUM MODE
- Keep the windows and doors closed for an effective dehumidification.
- When used as dehumidifier only keep the air exhaust hose disconnected.
- Press the button to turn the appliance on.
- Press the MODE button to select DRY. The fan speed will always be on FAN
(Fan Speed Auto) and cannot be adjusted in DRY mode.
NOTE: When in the dehumidifier mode, you can use the drain located in the
middle of the back of the unit for external drainage.
To use:
1. Loosen the drain plug cover by turning counterclockwise and remove.
2. Connect the included hose on to the exposed drain plug thread.
FAN MODE
- Press the button to turn the appliance on.
- Press the MODE button to select FAN
- To select fan speed, press the FAN SPEED button repeatedly until the required
speed is selected (HIGH / MED / LOW) and AUTO FAN SPEED can not be
selected.
button.
repeatedly until the
Page 15 Page 15