General Information; Model Type Setting - Pioneer DVR-541H-S Service Manual

1

2. GENERAL INFORMATION

2.1 MODEL TYPE SETTING

A
[Purposes]
When the MAIN Assy and/or TUJB Assy that are(is)
commonly used with another model are(is) replaced,
they(it) must recognize the model of this unit.
Items to be set: The model number, destination, and
region No. must be set.
• Once the setting has been made, it can never be changed. Be sure to make the setting correctly.
B [Notes]
• As this setting resets the Assy(s) in question to the factory-preset status, it is recommended that you obtain
the customer's consent beforehand.
[Procedures]
1 After power on, the following screen is displayed on
TV monitor. Press four digits properly (" 0209 ") by
using the remote control unit for service,according to
the screen information.
C
Disconnect then reconnect the AC power cord of the
2
unit. Be careful not to impart vibration to the unit
immediately after the AC power cord is disconnected.
D
Reset the recorder to all its factory settings.
3
(Make sure that the recorder is on. Press and hold 7
(STOP) key and press
front panel.)
The recorder turns off with all settings reset.
4
Press [ESC] then [DISP] keys by using the remote
control unit for servicing, and then confirm each
E
Model Name (" DVR-541H/RDR ").
End
5
F
6
1
2
(STANDBY/ON) key on the
DVR-541H-S
2
3
[Tool to be used]
Remote control unit for servicing
(GGF1381)
[Recorder's Model Setting]
Input the number using the remote for Service.
> - - -
Input No. Model
[ 0208 : DVR-541H/RF ]
[ 0209 : DVR-541H/RDR ]
DVR-541H/RDR VERSION : 1.∗∗
SYSCON : RELEASE_100
Rev :1.1000
TUNERCON : 198.000
DRIVE : DVD-RW DVR-L11X
1.00
HDD : WDC WD1600BB-xxJKCx
DEVICE : E2R-FE 1.2 FLASH : 64M
C : ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗
REGION : 4
3
4
OK
OK
OK
160
4