Configuring Ldp-Ospf Synchronization - HP 6127xlg Configuration Manual

You can execute the mpls ldp igp sync disable command to disable LDP-IGP synchronization on
interfaces where LDP-IGP synchronization is not required.

Configuring LDP-OSPF synchronization

LDP-IGP synchronization is not supported for an OSPF process and its OSPF areas if the OSPF process
belongs to a VPN instance.
To configure LDP-OSPF synchronization for an OSPF process:
Step
1. Enter system view.
2. Enter OSPF view.
3. Enable LDP-OSPF
synchronization.
4. Return to system view.
5. Enter interface view.
6. (Optional.) Disable LDP-IGP
synchronization on the
interface.
7. Return to system view.
8. Enter LDP view.
9. (Optional.) Set the delay for
LDP to notify IGP of the LDP
convergence.
10. (Optional.) Set the maximum
delay for LDP to notify IGP of
the LDP-IGP synchronization
status after an LDP restart or
active/standby switchover.
To configure LDP-OSPF synchronization for an OSPF area:
Step
1. Enter system view.
2. Enter OSPF view.
3. Enter area view.
4. Enable LDP-OSPF
synchronization.
5. Return to system view.
6. Enter interface view.
Command
system-view
ospf [ process-id | router-id
router-id ] *
mpls ldp sync
quit
interface interface-type
interface-number
mpls ldp igp sync disable
quit
mpls ldp
igp sync delay time
igp sync delay on-restart time
Command
system-view
ospf [ process-id | router-id
router-id ] *
area area-id
mpls ldp sync
quit
interface interface-type
interface-number
33
Remarks
N/A
N/A
By default, LDP-OSPF synchronization
is disabled.
N/A
N/A
By default, LDP-IGP synchronization is
not disabled on an interface.
N/A
N/A
By default, LDP immediately notifies
IGP of the LDP convergence
completion.
By default, the maximum notification
delay is 90 seconds.
Remarks
N/A
N/A
N/A
By default, LDP-OSPF
synchronization is disabled.
N/A
N/A