Configuring A Bgp Pw - HP 6127xlg Configuration Manual

Step
1. Enter system view.
2. Enter VSI view.
3. Specify LDP signaling
for PWs, and enter VSI
LDP signaling view.
4. Configure an LDP PW,
and enter VSI LDP PW
view.

Configuring a BGP PW

To configure a BGP PW, perform the following configurations on PEs:
• Configure BGP to advertise VPLS label block information.
Create a BGP PW.
•
Configuring BGP to advertise VPLS label block information
Step
1. Enter system view.
2. Enable BGP and enter BGP
view.
3. Configure the remote PE as a
BGP peer.
4. Create the BGP L2VPN
address family and enter BGP
L2VPN address family view.
5. Enable BGP to exchange
L2VPN information with the
specified peer or peer group.
6. Enable BGP to exchange
label block information with
the specified peer or peer
group.
Command
system-view
vsi vsi-name
pwsignaling ldp
peer ip-address [ pw-id pw-id ]
[ no-split-horizon | pw-class
class-name | tunnel-policy
tunnel-policy-name ] *
Command
system-view
bgp as-number
peer { group-name | ip-address
[ mask-length ] } as-number
as-number
address-family l2vpn
peer { group-name | ip-address
[ mask-length ] } enable
peer { group-name | ip-address
[ mask-length ] } signaling
380
Remarks
N/A
N/A
By default, no PW signaling protocol is
specified.
By default, no LDP PW is configured.
If both a default PW ID in the
default-pw-id command and a PW ID in
the peer command are configured, the
PW ID in the peer command is used. If
only a default PW ID is configured, the
default PW ID is used. If no default PW
ID is configured, you must provide a PW
ID in the peer command.
You must specify the no-split-horizon
keyword to disable split horizon when
you configure an NPE to establish a
U-PW to a UPE.
Remarks
N/A
By default, BGP is not enabled.
By default, no BGP peer is
configured.
By default, the BGP L2VPN
address family is not created.
By default, BGP cannot exchange
L2VPN information with any peer
or peer group.
By default, BGP can exchange
label block information with a
BGP L2VPN peer or peer group.