Makita HR5000K Instruction Manual
  1. Manuals
  2. Brands
  3. Makita Manuals
  4. Rotary Hammer
  5. HR5000K
  6. Instruction manual
Makita HR5000K Instruction Manual

Makita HR5000K Instruction Manual

Hide thumbs Also See for HR5000K:
Table of Contents

Advertisement

Quick Links

See also: Instruction Manual
INSTRUCTION MANUAL
Rotary Hammer
HR5000
HR5000K
003101
DOUBLE INSULATION
IMPORTANT: Read Before Using.
1

Advertisement

Table of Contents
loading

Related Manuals for Makita HR5000K

Summary of Contents for Makita HR5000K

  • Page 1 INSTRUCTION MANUAL Rotary Hammer HR5000 HR5000K 003101 DOUBLE INSULATION IMPORTANT: Read Before Using.

  • Page 2: Specifications

    ENGLISH (Original instructions) SPECIFICATIONS Model HR5000 HR5000K Carbide-tipped bit 50 mm 50 mm Capacities Concrete 150 mm 150 mm Core bit Hume pipe 255 mm 255 mm No load speed (min Blows per minute 2,100 2,100 Overall length 476 mm...

  • Page 3: Rotary Hammer Safety Warnings

    When operating a power tool outdoors, use an must be repaired. extension cord suitable for outdoor use. Use of 20. Disconnect the plug from the power source a cord suitable for outdoor use reduces the risk of and/or the battery pack from the power tool electric shock.

  • Page 4: Functional Description

    mask and thickly padded gloves. FUNCTIONAL DESCRIPTION Be sure the bit is secured in place before operation. Under normal operation, the tool is designed CAUTION: to produce vibration. The screws can come Always be sure that the tool is switched off and •...

  • Page 5: Operation

    CAUTION: ASSEMBLY Never use A-type shank bits. They can cause • damage to the tool. CAUTION: Always be sure that the tool is switched off and • unplugged before carrying out any work on the tool. 38.5 Side handle 16ø 1.
  • Page 6 Rest the core bit on the concrete and turn the tool on. Blow-out bulb (optional accessory) Once the core bit has cut a shallow groove into the concrete, remove the center bit. Then resume drilling. 1. Blow-out bulb 002449 After drilling the hole, use the blow-out bulb to clean the 003212 dust out of the hole.

  • Page 7: Maintenance

    When this occurs, both carbon Remove the crank cap using a Makita lock nut wrench brushes should be replaced. Keep the carbon brushes 35 (optional accessory). Rest the tool on the table with clean and free to slip in the holders.
  • Page 8 003244 Wipe out the old grease inside and replace with a fresh grease (90 g; 3 oz). Use only Makita genuine hammer grease (optional accessory). Filling with more than the specified amount of grease (approx. 90 g; 3 oz) can cause faulty hammering action or tool failure.
  • Page 12 Makita Corporation www.makita.com 883643J1...

This manual is also suitable for:

Hr5000

Table of Contents