Disassembly
Removing and Replacing the Keypad
30
1.
Remove the battery cover, battery, SIM, rear housing, and transceiver PC
board, as described in the procedures.
2.
Lift the keypad up from one corner as shown in Figure 16 and remove it from
the front housing.
Figure 16. Removing and Replacing the Keypad
3.
To replace, align the keypad holes with the front housing pins and place the
keypad onto the front housing.
4.
Reassemble the front housing, transceiver PC board, transceiver PC board
shield, antenna cap, SIM, battery and battery cover as described in the
procedures.
September 23, 2005
Motorola SLVR L7
Keypad
Alignment pin
Front housing
050979o
6809495A77-O