Advertisement
6
Before hanging the sound columns on the
hanger, activate the damper stopper.
Position the sound column with its pitch in-
scription facing forward, place one side of the
wire into the slot of the hanger pin. Next, hook
the wire on the round head rivet, finally place
the wire into the slot of the remaining hanger
pin.
When hanging the sound columns, it is easier
to hang the accidental tones (C#53-F#70) first,
then hang the natural tones (C52-G71).
CHS-506
1
With the fixing hole on the base bar aligned
with the bolt hole in the base, connect the
base bar to the base. Tighten the block bolt to
secure the base bar to the base. (The upper
end of the side column acts as tool to tighten
the block bolt. Insert the upper end of the col-
umn and tighten the block bolt by rotating the
side column.)
Base
Block Bolt
2
After tightening the block bolt, re-insert the
side column into the base with making sure
that the side column's hanger attachment po-
sitioned upright.
Side Column
Base Bar
* Disassembly is performed simply by reversing the assembly order.
ASSEMBLY PROCEDURE
Side Column
Hanger Bar Attachment
Fixing Hole
Base Bar
CH-500
Hanger Pin
Sound Column
3
Fit the guide board onto the side columns
and lower the guide board until it rests on the
board rest.
Guide Board
4
Attach the hanger bar on the top of the side
columns and secure with the wing bolts. At
this time, also tighten the wing bolts on the
side column and base.
Side Column
5
Position the sound column with its pitch in-
scription facing forward, and attach the sound
column to the hanger bar.
Hanger Pin
Sound Column
Wire
Round Head
Rivet
Hanger Pin
Teflon Tube
Board Rest
Hanger Bar
Wire
Round Head
Rivet
Hanger Pin
Teflon Tube
9
Advertisement
