Advertisement
CH-500/CHS-520
1
Insert the side columns into the base. At this
time, make sure that the damper rest, at-
tached at the center of the column, and the
short section of the column is positioned up-
right.
Side Column
Damper Rest
2
Fit the damper onto the side columns and
lower the damper onto the damper rest. Next,
secure the damper in its position with the
damper fixing bolts. At this time, tighten the
fixing bolts that secure the side column to the
base as well.
Damper
Damper Stay
8
ASSEMBLY PROCEDURE
Short Section
Long Section
Base
Fixing Bolt
Side Column
Damper Rest
3
Remove the damper stay, attached to the
bottom of the damper, loosen the wing bolt
on the damper stay, and attach the stay to
the pedal hook. The pedal's position can
be controlled by adjusting the length of the
pedal stay with its two wing bolts. At this time,
tighten the upper wing bolt first, then go on to
tighten the lower bolt.
Adjust the pedal position so that the pedal
stops slightly above the floor when fully de-
pressed.
Damper Stay
Pedal Hook
4
Slide the hanger onto the side columns.
5
To activate the damper stopper, depress the
pedal and press the stopper. When the pedal
is released, the stopper will hold the damper
in place.
Base
Hanger
Side Column
Damper Stopper
Side Column
Advertisement
