Installation - GE JVB67 Owner's Manual & Installation Instructions

Installation of the downdraft system.
Step 3 is for 36" wide models only. Skip this step if installing a 30" model.
Install Raise/Lower Switch
Determine the location for the RAISE/LOWER
switch. The wiring lead is 72" long.
Drill a 1/8" hole into the desired location.
–If switch is mounted into a tile surface, drill
the hole between tiles. Use locally approved
caulking to cover any gaps.
Thread the wire lead through the top of
the countertop.
Thread the wire lead into the end of the
wire box.
Push wire metal leads into the white
connector plug.
Plug the connector into the control box.
Place plastic strain relief over wire, the
wire should be flat and fit into the area.
Do not pinch or twist the wire. Snap the
strain relief closed.
Push the strain relief into the hole on the wire
box. It will snap into position.
Secure wire box to vent with screws provided.
Center the mounting bracket over the hole and
mark pilot holes. Remove and drill pilot holes.
Mount the metal switch bracket with screws
(not provided, choose screws for your type of
countertop or use locally approved adhesive).
Tie a knot in the lead as close to the switch as
possible. This will prevent the lead from being
pulled away from the switch.
Peel film from the back of the switch trim to
expose the adhesive.
Press trim onto the mounting bracket to set
the adhesive.
IMPORTANT: Do not connect wire leads to white
connector until you have threaded the lead
through the countertop hole and through the
end of the wire box.
Push wire metal leads into the white
connector plug.
Place plastic strain relief over wire, the
wire should be flat and fit into the area.
Do not pinch or twist the wire. Snap the
strain relief closed.
Push the strain relief into the hole on the wire
box. It will snap into position.
Secure wire box to vent with screws provided.
16
Read these instructions completely and carefully.
Knot
2 Pin connector
Pull 2" length
out of box
Trim
Mounting
bracket
Hole
Thread electrical
leads through hole
Leads
Strain relief