Venting - GE JVB67 Owner's Manual & Installation Instructions

Installation of the downdraft system.
Venting Options
Side to side adjustments:
The entire blower mounting plate can be adjusted
" to the left or right. This will help to align vent
3 ⁄
1
2
discharge to house ductwork.
30° Rotation
For even more flexibility, the entire blower can be
rotated up to 30° towards the left or 30° towards
to right.
Discharge direction
The blower assembly may be removed and turned
90° for a left or right side discharge.
The downdraft vent is shipped with the discharge
outlet pointing straight down and can be changed
to the left or right side.
A left or right 90° direction adjustment should be
performed before dropping into the countertop
opening.
Flatten the shipping box to use as a pad.
Lay the vent on its back onto the pad.
To change to a left or right discharge:
Remove 4 nuts holding the blower to the
mounting plate. See illustration. One nut is just
inside the blower discharge.
Remove and turn the blower to the right or left.
Reinstall the 4 nuts.
To locate the ductwork holes in the cabinet floor
or side walls:
Temporarily, place vent into the countertop
opening.
Push the vent all the way to the back of the
opening.
If you are transitioning to 6" round, place
transition piece over the discharge outlet.
– Mark the location and remove the assembly.
– Cut holes and install ductwork connections.
Order JXRB57 for installation of the blower and motor below
the floor:
Order JXBC57 for installation of the blower and motor
outdoors.
14
Read these instructions completely and carefully.
Loosen screws to adjust
blower left to right
Nut location inside the
blower discharge
30" Rotation left or right
Discharge down
(as supplied)
Discharge right
Discharge left