Cisco ASR 901S Series Installation Manual page 78

Enabling Zero Touch Provisioning on the Router
Procedure
Step 1 Use a Phillips screwdriver to remove the zero touch provisioning (ZTP) reset button screw. Be careful not to
loose the screw.
Step 2
Use a straightened paperclip, thin non-metallic pin, or thin non-metallic pin no larger than 3/16 inches in
diameter and push the ZTP reset button for 0.5 seconds to initiate zero touch provisioning. (See the following
figure.)
Figure 43: Accessing the ZTP Reset Button
1
Push the ZTP reset button for more than 8 seconds to reboot (power cycle) the router; all LEDs will turn off
for approximately 5 seconds, and then the LEDs will reactivate. For information on LEDs, see
, on page
Step 3 Replace the reset button screw and use a Phillips screwdriver to tighten to 22 to 24 in. lbs (2.49 to 2.71 Nm).
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
68
78.
ZTP reset button
Installing the Router
Reading LEDs
OL-29732-01