After Use; Inspection And Repairs - Black & Decker GWC1815 Original Instructions Manual

ENGLISH

After use

When not in use, the appliance should
u
be stored in a dry, well ventilated place
out of reach of children.
Children should not have access to
u
stored appliances.
When the appliance is stored or trans-
u
ported in a vehicle it should be placed
in the boot or restrained to prevent
movement following sudden changes
in speed or direction.

Inspection and repairs

Before use, check the appliance for
u
damaged or defective parts. Check for
breakage of parts and any other condi-
tions that may affect its operation.
Do not use the appliance if any part is
u
damaged or defective.
Have any damaged or defective parts
u
repaired or replaced by an authorised
repair agent.
Never attempt to remove or replace
u
any parts other than those specified in
this manual.
Additional safety instructions for
blowers
The intended use is described in this
manual. The use of any accessory or
attachment or performance of any opera-
tion with this appliance other than those
recommended in this instruction manual
can present a risk of personal injury and/
or damage to property.
To protect your feet and legs while
u
operating the appliance, always wear
heavy duty footwear and long trousers.
Always switch off your product, allow
u
the fan to stop and remove the battery
when:
You leave your product unattended.
u
Clearing a blockage.
u
6
(Original instructions)
Checking, adjusting, cleaning or
u
working on your product.
If the appliance starts to vibrate
u
abnormally.
Do not place the inlet or outlet of
u
the vacuum near eyes or ears when
operating. Never blow debris in the
direction of bystanders.
Do not use in the rain or leave out-
u
doors while it is raining.
Do not cross gravel paths or roads
u
whilst your product is switched. Walk,
never run.
Do not place your unit down on gravel
u
while it is switched on.
Always be sure of your footing, particu-
u
larly on slopes. Do not overreach and
keep your balance at all times.
Do not place any objects into the
u
openings. Never use if the openings
are blocked - keep free of hair, lint,
dust and anything that may reduce the
airflow.
Vibration
The declared vibration emission values
stated in the technical data and the
declaration of conformity have been
measured in accordance with a standard
test method provided by EN50636 and
may be used for comparing one tool with
another. The declared vibration emission
value may also be used in a preliminary
assessment of exposure.
Warning! The vibration emission value
during actual use of the power tool can
differ from the declared value depending
on the ways in which the tool is used.
The vibration level may increase above
the level stated.