Description,Specifications And Standard Equipment Description; Specifications; Standard Equipment - RIDGID SeekTech ST-510 Manual

SeekTech
the only way to verify its existence, location and
depth.
• Avoid traffic. Pay close attention to moving vehicles
when using on or near roadways. Wear visible clothing
or reflector vests.
• Use equipment only as directed. Do not use the
transmitter and related equipment unless the operator's
manual has been read.
NOTICE Ridge Tool Company, its affiliates and sup-
pliers, will not be liable for any injury or any direct, indi-
rect, incidental or consequential damages sustained or
incurred by reason of the use of the SeekTech ST-510
line transmitter.
Description, Specifications
And Standard Equipment
Description
The RIDGID ® SeekTech ST-510 line transmitter is part of
the RIDGID SeekTech cable and pipe locating system. The
ST-510 is used to generate an "active" signal on a metal-
lic underground line so that it may be traced with a com-
patible receiver such as the SeekTech SR-20 or SR-60.
This allows the line's location to be correctly marked so it
can be exposed for repair or avoided during excavation.
The ST-510 line transmitter can apply an active tracing sig-
nal to a target conductor in three ways:
1. Direct Connect Method – The transmitter's leads are
connected directly to the target conductor and a suit-
able ground (See page 8) .
2. Inductive Clamp Method (optional accessory) –
The jaws of the inductive clamp encircle the target
conductor; there is no metal-to-metal contact (See
page 9) .
3. Inductive Mode – The transmitter is placed over,
and in-line with, a conductor. Its internal antenna in-
duces a signal onto the target conductor (See page
9) .

Specifications

Power Source................8 Alkaline or rechargeable
batteries.(D-Cells)
High Voltage Indicator
Features: AUTO Shut Off,
Battery Saver Mode,
AutoBack Light
Weight ...........................4.75 lbs (2.15 kg) w/o batteries,
7.5 lbs (3.4 kg) w/batteries
4
® ST-510 Line Transmitter
Ridge Tool Company
Dimensions:
Length .........................7.0" (17.8 cm)
Width ...........................15" (38.1 cm)
Height ..........................6.5" (16.5 cm)
Cable Length ...............48' Extended (14m); 46" con-
tracted (1.1m)
Output Power ................Nominal 10 watts max. 1 watt
maximum if frequency is
above 45kHz. Maximum out-
put voltage 30V RMS; ~ 48V
peak
Power Settings: .............4 mA, 15 mA, 50 mA, 150 mA,
600 mA
Default Settings: ............60 Hz Mode, 2 Hr. Shutoff,
30V-RMS Maximum,
SeekTech frequencies loaded
FCC Limits.....................47 CFR 15.213 says that from
9kHz up to (but not including)
45kHz, peak output power
shall not exceed 10 W. From
45kHz to 490kHz, it must not
exceed 1W.

Standard Equipment

• SeekTech ST-510 Transmitter
• Direct connect leads and clips
• Operator's Manual
• 8 D-cell batteries (Alkaline)
• Grounding Stake