Hinge Assembly; Dc-In Connector, Battery Terminal Board - Sony DCR-PC100 Service Manual

2-6. HINGE ASSEMBLY

Perform the disassembling after steps 1 – 6 of 2-1 is complete.
[REMOVING THE HINGE ASSEMBLY]
4 Blind plate assembly
3 Remove
the two claws
7 Hinge assembly
5 Peel off the adhering portion.
6 FP-129 flexible board
2-7. DC-IN CONNECTOR, BATTERY TERMINAL BOARD, FJ-25 BOARD
5 Remove
the two claws
6 Terminal
fixed plate
4 Screw
(M1.7 × 2.5),
lock ace, p2
2 DC fixed plate
1 PT-125
8
harness
(4P)
2 PT-126
harness
7 Two screws
(13P)
(M1.7 × 4),
lock ace, p2
6 Two spring bolts
(M1.7 × 2.5)
7 Battery terminal board
3 DC-IN connector
1 Screw
(M1.7 × 2.5),
lock ace, p2
8 Two screws
(M1.7 × 2.5),
lock ace, p2
qa Two screws
(M1.7 × 2.5),
lock ace, p2
9 Screw
qs FJ-25 board
(M1.7 × 2.5),
lock ace, p2
2-6
1 Release the claw (a) in the
direction of the arrow B first
then release the two claws (b).
claw (b)
B
claw (a)
claw (b)
2 Hinge cover (front)
C
3 Change the direction
of the hinge assembly
to the direction shown
by the arrow (C).
5 Hinge cover (rear)
4 Screw
(M1.7 × 2.5),
lock ace, p2
q; Open the
S terminal cover
in the direction of
the arrow A
A