Makita 906H Instruction Manual page 6

Installing or removing wheel point
CAUTION :
Always be sure that the tool is switched off and unplugged before installing or removing
the wheel point.
Loosen the collet nut and insert the wheel
point into the collet nut. Use the smaller
wrench t o hold the spindle and the larger
one to tighten the collet nut securely.
The wheel point should not be mounted
more than
10
mm
(3/8")
from the collet
nut.
Exceeding this distance could cause vibra-
tion or a broken shaft.
I
+ t -
10 mm (3/8")
To remove the wheel point, follow the installation procedure in reverse.
To start the tool, move the switch lever to
the "ON" position. To stop, move the
switch lever to the "OFF" position.
I
Switch lever
I I
6