Product Specifications - Hitachi P 13F Instruction Manual And Safety Instructions

Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals known to the state of California to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
● Lead based paints
● Crystalline silica from bricks, cement and other masonry products
● Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area and work with approved safety equipment, such
as dust masks that are specially designed to filter out microscopic particles.

PRODUCT SPECIFICATIONS

13" (330mm) PLANER
.............................................................................................................................................................
Voltage.
................................................................................................................................................................
Watts.
................................................................................................................................................................
Amps.
.............................................................................................................................................
Max cutting width
...............................................................................................................................................
Thickness of cut
.....................................................................................................................................
Maximum depth of cut
......................................................................................................................................................
Feed speed
..............................................................................................................................................
Number of blade
.................................................................................................................................................
No load Speed
...............................................................................................................................................................
Weight
Through poor conditions of the electrical MAINS, shortly voltage drops can appear when starting the EQUIPMENT.
This can influence other equipment (e.g. blinking of a lamp).
If the MAINS-IMPEDANCE Zmax < 0.23 OHM, such disturbances are not expected.
(In case of need, you may contact your local supply authority for further information).
To avoid electrical hazards, fire hazards or damage to the planer, use proper circuit protection.
This planer is wired at the factory for 230-240 Volt operation. It must be connected to a 230-240 Volt / 8 Ampere
time delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn, cut or
damaged in any way.
Before using your planer, it is critical that you read and understand these safety rules. Failure to follow these
rules could result in serious injury to you or damage to the planer.
WARNING
WARNING
– 3 –
English
230-240V / 50Hz
1800W
8A
13" (330 mm)
Min. 1/8" (3.2 mm)
3/32" (2.4 mm)
0.12 m/s
2
min
9,250/
101.4 lbs (46 kg)