Makita DP2010 Technical Information page 9

W
iring diagram
Fig. D-4
Route Choke coil's lead wires (purple)
between Rib E and the inner wall.
Do not put any Lead
wires on this Boss.
Choke coil with
Lead wire (orange)
Route Field lead wires
(black) through Lead
wire holders without
crossing each other.
Do not put any Lead
wires on Rib G.
Rib G
Noise suppressor
Wiring in Housing set (L)
Fix Choke coil's lead wires (purple)
in Lead wire holder.
Rib E
Rib F
Rib H
Sheath of Power
supply cord
Route Choke coil lead wire (orange)
between Rib F and the inner wall in
Switch side. (when using Choke coil)
Do not put any Lead
wires on Rib H.
Put Noise suppressor under Lead wires of Power supply
cord as shown on the left. (when using Noise suppressor)
line (Z)
Boss
The end of Sheath should not be crossed
over the line (Z) toward Switch.
Choke coil with
Lead wire (purple)
Put Choke coil with Lead
wire (purple) in the position
shown on the left.
(when using Choke coil)
P 9 / 9