Cisco ASR 920 Series Installing Manual page 14

Hide thumbs Also See for ASR 920 Series:

Installing the DC Power Supply

When installing DC power supply, use 14 AWG, 90°C wires. Always ensure that the building's

Note

installation for short-circuit (overcurrent) protection does not exceed 15A.

The DC connector or terminal block has an inbuilt screw and cage nut to which a torque of 1.3 to 1.8

Note

N-m can be applied.

Figure 3-13

To attach the DC power supplies:

Step 1

Open the DC power supply guard.

Step 2

Attach the DC supply wires in the designated screws. See

Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide

3-14

DC Connector With Inbuilt Screw

0.97 inches

0.31 inches

Chapter 3

0.27 inches

0.81 inches

Figure

Installing the Cisco ASR 920 Series Router

3-14.

OL-32751-01

Table of Contents