3. Check:
• Tightening torques
Exhaust pipe bolt 1 and nut "1"
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Exhaust pipe 1 and exhaust pipe
2 bolt "2"
12 Nm (1.2 m·kgf, 8.7 ft·lbf)
Exhaust pipe 2 and silencer bolt
"3"
12 Nm (1.2 m·kgf, 8.7 ft·lbf)
Silencer and silencer bracket bolt
"4"
30 Nm (3.0 m·kgf, 22 ft·lbf)
2
4
4. Install:
• Exhaust pipe protector
Exhaust pipe protector screw
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
LOCTITE®
CHECKING THE FUEL LINE
EAS2GC1095
1. Remove:
• Seat
• Side cover (left/right)
• Air scoop (left/right)
Refer to "GENERAL CHASSIS" on page 5-
1.
• Fuel tank
Refer to "FUEL TANK" on page 8-1.
2. Check:
• Fuel hose "1"
Crack/damage Replace.
Loose connection Connect properly.
3. Install:
CHECKING THE ENGINE OIL LEVEL
EAS2GC1096
1
1. Stand the vehicle upright on a level surface.
2. Start the engine, warm this up for 2–3 min-
TIP
This model is equipped with an engine auto-
stop system. The engine stops automatically if
left idling for 7 minutes. If the engine stops,
3
push the start switch or push down the kick-
starter lever to restart the engine.
3. Check:
ECA33DD018
3-16
• Fuel tank
Refer to "FUEL TANK" on page 8-1.
• Air scoop (left/right)
• Seat
• Side cover (left/right)
Refer to "GENERAL CHASSIS" on page 5-
1.
utes, and then stop the engine and wait
about 1 minute.
• Oil level
Make sure that the engine oil level is above
the minimum level mark "a" shown for the oil
level check window "1", and that the engine
oil does not come out by removing the oil
check bolt "2".
The minimum level mark "a" or below Add
the engine oil until its level exceeds the min-
imum level mark "a".
Engine oil coming out of the oil check bolt
Drain it until its last drop is out.
1
2
ENGINE
1
a