2
4
4
4. Install:
• Exhaust pipe protector
Exhaust pipe protector screw
10 N·m (1.0 kgf·m, 7.4 lb·ft)
LOCTITE®
EAM30222
CHECKING THE FUEL LINE
1. Remove:
• Seat
• Side cover (left/right)
• Air scoop (left/right)
Refer to "GENERAL CHASSIS" on page 4-1.
• Fuel tank
Refer to "FUEL TANK" on page 7-1.
2. Check:
• Fuel hose "1"
Crack/damage Replace.
Loose connection Connect properly.
3. Install:
• Fuel tank
Refer to "FUEL TANK" on page 7-1.
• Air scoop (left/right)
• Seat
• Side cover (left/right)
Refer to "GENERAL CHASSIS" on page 4-1.
EAM30224
1
CHECKING THE ENGINE OIL LEVEL
1. Stand the vehicle upright on a level surface.
2. Start the engine, warm this up for 3 minutes,
and then stop the engine and wait about 5
minute.
3. Check:
• Oil level
The engine oil level should be between the
minimum level mark "a" and maximum level
3
mark "b".
Below the minimum level mark Add the
recommended engine oil to the proper level.
ECA24290
NOTICE
• Since engine oil also lubricates the clutch,
the wrong oil types or additives could
cause clutch slippage. Therefore, do not
add any chemical additives.
• Do not allow foreign material to enter the
crankcase.
1
3-13
b
a
Recommended brand
YAMALUBE
SAE viscosity grades
10W-40, 10W-50, 15W-40, 20W-
40 or 20W-50
Recommended engine oil grade
API service SG type or higher,
JASO standard MA
ENGINE